1 Bộ Bánh Răng Đôi Cho Máy In 3d Prusa I3 Mk2 / Mk2S / Mk2.5
0 Đánh Giá
Đã Bán 0
83
65.000 đ
Xem sản phẩm trên Shopee
Cài đặt Bigbuy360 ExtensionQuốc tế
chủ nhật 23/05/2021 lúc 04:58 CH
MÔ TẢ SẢN PHẨM
How to use, pls follow the steps:
1. Press the nuts to the slots on both sides of the idler
2. Insert both bearings in the pulley,Be aware that bearings can slip out during assembly.(Layers might be visible in this printed part due to the geometry .The functionality and strength remain unaffected)
3. Ensure both bearings are inside the pulley!
4. Insert the pulley in idler as shown in the picture.
5. Slide the shaft through the idler and pulley.Use reasonable force or you will BREAK the printed part.
6. Place your finger on the bearing and ensure it can rotate freely.
colour:Sier
Material:metal
Package Contents:
1 * pulley (with the lock screw)
1 * pulley (without the lock screw)
2 * pulley bearing
2 * Nuts
1 * pulley shaftOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
1. Press the nuts to the slots on both sides of the idler
2. Insert both bearings in the pulley,Be aware that bearings can slip out during assembly.(Layers might be visible in this printed part due to the geometry .The functionality and strength remain unaffected)
3. Ensure both bearings are inside the pulley!
4. Insert the pulley in idler as shown in the picture.
5. Slide the shaft through the idler and pulley.Use reasonable force or you will BREAK the printed part.
6. Place your finger on the bearing and ensure it can rotate freely.
colour:Sier
Material:metal
Package Contents:
1 * pulley (with the lock screw)
1 * pulley (without the lock screw)
2 * pulley bearing
2 * Nuts
1 * pulley shaftOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
